How Do I Put on a Lace Front Wig? Step-by-Step Guide for Beginners

Step 1: Gather Your Tools for Lace Front Wig Application

• A breathable wig cap for lace front wigs (to hold your natural hair in place and prevent slippage).
• Safe lace front wig glue for sensitive scalps (or wig tape, if you prefer no-glue options—we sell both at www.wigsvana.com).
• A wide-tooth comb (for detangling your natural hair and the wig).
• Small scissors (for trimming excess lace—choose sharp, precise ones to avoid mistakes).
• A mirror (preferably a full-length one to check the back and sides).

Step 2: Prep Your Natural Hair & Scalp

1. Wash and dry your natural hair (oily hair can make wig glue/tape less effective).
2. Braid your hair into small cornrows (or pull it back into a low bun if it’s short)—this keeps hair flat under the wig cap.
3. Put on the sweat-resistant wig cap for all-day wear and tuck any loose hair under the cap. Secure the cap with bobby pins if needed (focus on the hairline and nape).
4. Wipe your forehead (where the lace will sit) with a gentle cleanser to remove oils—this helps glue/tape adhere better.

Step 3: Position the Lace Front Wig Correctly

1. Hold the wig by the ear tabs and gently stretch it over your head. Start by aligning the front lace with your natural hairline (leave a small gap—about 1/8 inch—for a more realistic look).
2. Adjust the back of the wig so it sits comfortably at the nape of your neck—our adjustable lace front wigs for perfect fit have straps in the back, so you can tighten or loosen as needed.
3. Check the sides: Make sure the ear tabs line up with your ears (this keeps the wig from looking lopsided).

Step 4: Secure the Wig & Trim Excess Lace

1. If using glue: Apply a thin line of strong-hold but gentle wig glue along the edge of the lace (avoid getting glue on the wig fibers!). Wait 30 seconds for the glue to get tacky, then press the lace firmly onto your forehead. Hold for 1–2 minutes to set.
2. If using tape: Cut small strips of no-residue wig tape for lace front wigs and attach them to the inside edge of the lace. Peel the backing and press the lace onto your scalp.
3. Trim the excess lace: Use small scissors to cut along the hairline (leave about 1/4 inch of lace to blend with your skin—don’t cut too close!). For beginners, cut in small, slow snips to avoid mistakes.

Step 5: Style & Blend for a Natural Look

1. Gently comb the wig with a soft bristle brush for wig care (avoid pulling—this can damage lace).
2. If you have a heat-resistant lace front wig (like our human hair options at www.wigsvana.com), you can use a low-heat flat iron or curling wand to add subtle waves—match the style to your natural hair for extra realism.
3. Use a small amount of concealer (matching your skin tone) along the lace edge to blend it with your forehead—this hides any remaining lace lines.

Common Mistakes to Avoid When Putting on Lace Front Wigs

• Using too much glue (it can seep into wig fibers and cause tangling).
• Cutting the lace too close (this leads to fraying and a unnatural hairline).
• Skipping the wig cap (your natural hair can poke through, ruining the look).